![]() # Psion 56k + 10Mb Ethernet 400019-16C logs]# service network startīringing up interface eth0: Device eth0 has different MAC address than expected, logs]# For logs]# cat /etc/sysconfig/network-scripts/ifcfg-eth0 This includes the output of getinfo.sh and some command line output. Any suggestions from the forum regulars? I have several pieces of supporting information ready to upload or include in this call. system-config-network reports the IRQ is unknown. I've also seen some interrupt and IRQ errors in dmesg. Hoiwever, system-config-network does report that the card is bound to MAC 00:60:62:01:F4:84 and this same address appears in ifcfg-eth0. Part of the problem is that I don't know what that HWADDR should be as I don't have the original manual. I've googled for the above message and most results say to check /etc/sysconfig/network-scripts/ifcfg-eth0 and change the HWADDR parameter to the correct MAC address. "Device eth0 has different MAC address than expected, ignoring"Īnd the network card doesn't start up at boot. ![]() The install ran smoothly but on first reboot the eth0 network card reported: ![]() This is the only network card on the machine. I'm using a Celeron laptop from Tiny Computers (now defunct company) with a Psion Gold Card 56K+10Mb Ethernet pcmcia card. I'm experiencing some network problems when re-using some old (10+ years) hardware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |